# # PhoenixMiner ethash pools list (you MUST rename this files to epools.txt in order to use it) # # The pools specified in this file will be added to the pools specified with the PhoenixMiner's # command-line options (see -pool and -pool2 command line options). # # Alternatively, you can omit the -pool option on the command-line and use only the pools in # epools.txt file. This will give you the ability to specify more than two pools, and to change # the pools without restarting the miner by using the 'r' key in the PhoenixMiner console to # reload the epools.txt file. # # You must put one pool per line as specified in the examples below # If the line starts with '#' it will be ignored as comment # # NOTE: PhoenixMiner also "understands" the epools.txt files from Claymore's dual Ethereum miner # # IMPORTANT: Replace the ETH address with your own ETH wallet address in the WAL: option (Rig001 is the name of the rig) # # These are examples for ETC pools POOL: eu1.ethermine.org:4444, WAL: 0x35D14dC3133EDA8A6cB7C9011Ab53473118d74bF.Rig001 POOL: eu1.ethermine.org:4444, WAL: 0x35D14dC3133EDA8A6cB7C9011Ab53473118d74bF.Rig001 POOL: eu1.ethermine.org:4444, WAL: 0x35D14dC3133EDA8A6cB7C9011Ab53473118d74bF.Rig001 POOL: eu1-etc.ethermine.org:4444, WAL: 0x71889Be2507770156253430d413Fe0b593618af1.Rig001, COIN: etc POOL: eu1-etc.ethermine.org:4444, WAL: 0x71889Be2507770156253430d413Fe0b593618af1.Rig001, COIN: etc POOL: eu.emcd.io:7878, WALLET: gpf.worker, PSW: x, ESM: 0, ALLPOOLS: 0 POOL: eu.emcd.io:7878, WALLET: gpf.worker, PSW: x, ESM: 2, ALLPOOLS: 0 POOL: etc-eu1.nanopool.org:19999, WAL: 0x71889Be2507770156253430d413Fe0b593618af1.Rig001, COIN: etc # The following line shows all possible pool options. The values for each option must follow the # same rules as these specified in the Readme.txt file for the -pool, -wal, -pass, -worker, # -proto, -coin, and -stales command-line options